CMU200 LABVIEW DRIVER DOWNLOAD

The generated image will be uploaded to the host PC. I had done it before for some vis. If you do not need to use secondary address, you don’t have to use any value for this part. B Operating Manual Application Note Michael Manert I have to configure the CMU in order to make a call and perform some measurements.

Uploader: Arall
Date Added: 12 July 2005
File Size: 63.41 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 77077
Price: Free* [*Free Regsitration Required]

R&S®CMU200 – Instrument Drivers

Do you have any suggestions? Also I am attaching the NI spy snapshot. Secure Communications Data Sheet Customer satisfaction 5 1.

Due to a different file system in different instrument families a corresponding filename for the hardcopy image must be set. This is done in line 28 and described in chapter 3. The occurred error will be evaluated and show in a pop-up window afterwards.

Broadcasting Product Brochure The device descriptor you used “GPIB This is shown in Figure 3. Secure Communications Product Brochure Bluetooth is a trademark owned More information. Please have a look at chapter 3.

LabVIEW-CMU200 help!

In line 25 this file on the instrument will be deleted. This is done in line 31 to This is done in line 36 cmh200 described in chapter 3. You can also try to assign a different address to the device. It also has capabilities to clear the remote control bus in case of pending operations.

New Drivers  TOSHIBA SATELLITE A105-S101 DRIVER FOR WINDOWS 10

CMU SaveRecall – Discussion Forums – National Instruments

Both methods are simple ways to establish communications with your instrument. Hardware description 7 2. After the hardcopy is triggered in line 31 the generated image will be uploaded to the host PC. If you do not query the instrument when you kabview it, the firmware is treated as 0 and all subsequent commands will error with an insufficient firmware revision error message.

My problem is that every time I run this vi I get an error telling me that my window length must be less than my signal length but greater than zero. This application note covers the following instruments: Still cant figure out? In the source code below line 13 specifies which file will be loaded from the instrument and stored on the host PC.

I am finding a hard time in dealing with the drivers.

Company headquarters are in Munich, Germany. Can you do a query in MAX? You will be sent an email which will enable you to download the presentations and an More information. After the hardcopy is configured and triggered in line 15 the generated image will be uploaded oabview the host PC. But i need help to use that for establishing the link and retrieving the spectrum dmu200.

New Drivers  XEROX DOCUMATE 152 SCANNER DRIVER

This is shown in Figure 6.

In the application note 1MA After the hardcopy was triggered in line 31 the generated image will be uploaded to host PC. To make this website work, we log user data and share it with processors.

I have to configure the CMU in order to make a call and perform some measurements.